Cancel search

Not sure which PH is bad

#1 faridsk 7 months ago

Can someone look at my plot and tell me which PH I need to replace. I have been told to replace the Black/Cyan PH but i see the bands on Light Cyan (or I may be wrong). However also to note is that I have recently replaced the LM/LC PH but I am suspecting that is the one that is problematic. My PH status shows both Black/Cyan are fine (or maybe I am not reading it right). Any help is appreciated.

#2 HP Daniela Ciolompea 6 months ago

Hi @faridsk,

Looking at the pictures you attached, you should clean C/B printhead before trying to change it for a new one. In addition to this, I would recommend doing a full printhead clean just in case. I hope it helps.

Was this helpful?Yes0 No0
How can we improve it?
#3 faridsk 6 months ago

It was the LC/LM and not the C/B. I replaced it and the banding is gone

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex


HP Latex Blog


A place to learn, grow and discover