Hello. problem by printing on the wallpaper digimura RP premium. I have traces apparently due to a friction of the media in the oven. What is the solution? what profile do you use for this media? Thank you for your answers
From the pictures seems like the print is slightly touching the curing module.
Are you using Take Up Reel or it s not installed ? Because it will be a good point to put tension between printzone and outputzone.
My suggestions are: (a part of intall Take Up Reel):
We have tested the Digimura 2.1 Tactile you can download the profile from the below: http://h19002.www1.hp.com/pub/softlib/latex/Latex360/hp_l3x0_papergraphics_ltd_digimura_2_1_tactile.oms
I hope this information helps
thank you very much @#2HP-Sonia
I made an exit with this profile about 50 cm - I did not have the problem - I hope it will not appear on the longer outings - it's annoying (and especially not economical) of throw a print after 2.5m or 3m print
RememberTo make recommendations or participate please Sign In and post a message.