my problem is that we have a slight magenta touch in every print. We print on Sai Flexi 12 and have all the settings adjusted. The papers are all with profile. Shades of gray always get a color cast. Here are some examples. The printer colors are all right. The calibration charts are okay, too.
The test print from HP also shows the color wrong.
Maybe someone else has an idea of what we're doing wrong.
If all the Printheads are new and working fine, I would suggest making a color calibration and set it as a reference.
This reddish print could be due to a deffective printhead or maybe the color reference already set in the profile was done with some defect in the printhead, then even if the printhead has been replaced, the printer will try to get the most approached color based on the reference.
I also suggest you go through all the color articles that we have https://hplatexknowledgecenter.com/tag/color/posts I hope this information helps.
Thank you very much @HP-Sonia
If I understand correctly, do you assume a defective printhead? When I log in with the IP on the printer, the printheads are all displayed with OK and in warranty.
If the printheads print all properly, how can I detect a defect?
Is it possible to completely reset the printer to factory settings?
We recommend to be in optimal conditions to set the color reference. These conditions are:
For better understanding and as mentined un the User guide:
The first step, you may be able to improve print quality with a single command: At the front panel, press
"settings", then Image-quality maintenance > Optimize print quality.
This procedure performs printhead recovery, alignment, and color calibration routines, in order to optimize your print
quality automatically in a single step. Allow up to 30 minutes for the printer to perform the whole process.
If you still experience print-quality problems, you can follow a more hands-on print-quality troubleshooting
procedure, by printing, interpreting, and performing corrective actions.
You can print all the test plots at once for complete debugging of your print-quality problem: At the front
panel, press "settings" , then Image-quality maintenance > Print all test plots.
Alternatively, you can print the test plots individually for specific debugging of nozzle health, alignment,
optimizer, or substrate-advance print-quality issues.
Hope it helps,
The printer issue is one of the most irritating issue that we all more or less face, but there are some easy tricks too for avoiding the errors. I am now using canon printer and frequently I face Canon Printer Error C000, but after applying the tricks, this has been very rare. You can get the tricks from the Internet.
You can apply the same tricks but basically you are working with different technology. I am assuminf that's why it hasn't for much help.
I am also facing this kind of problem when I am using my printer for a few years, but recently when I search on google for that and I got help from
Was this helpful?Yes0
How can we improve it?
I faced the same problem with my hp printer and it couldn't be solved. Then I searched many websites for the solution from https://hp123-printer-setups.com/ and learned about 123.hp.com. Now my printer is working properly.
#3 You can locate suitable media profile from the HP Media Locator and install them.
You can also clone a generic profile and then make adjustments to them.
Do not run a colour calibration otherwise it may change it to have a slight Magenta cast.
if you need a fully managed colour calibration you might be better to do so with a portable Photo Spectrometer such as an I-Rite brand spectro to generate your final profiles and linearisations.
This is a limitation to the 315 and 335 printers due to them not having an in-built photo spectrometer installed. The colour readings are measuring densities and not the full colour.
Video guide to installing profiles:
Guides about profiles and colour:
RememberTo make recommendations or participate please Sign In and post a message.