Cancel search

Oily Chemical Drops

HP Latex 310 Printer

#1 Jonas 4 years ago

Hello HP Community,

Recently we had really long runs on our L360 and at the end of the day we set up a run that went through a good portion of the evening unattended. Before we started the new roll, I noticed drops of a clear and oily chemical were forming at the top of the curing unit. We cleaned it off with a cotton pad. The next morning we noticed that one of the large panels we printed had a drop on it that ruined the print. Any thoughts? Attrached are the pictures I took of the damaged print.

-Jonas

#2 HP-MarcM 4 years ago

Hi Jonas!

As I can tell from the pictures you have sent, I recommend to follow these tips:

  1. Be sure that the site is at the “best print quality” environmental conditions (Page 169 on the Latex 310 User Guide).
  2. Confirm that the air-conditioning system is not blowing cold air directly to the printer, this will increase the possibilities of having “cold” areas in the printer, so generates this kind of oil/substance. 3. Use a print-mode that uses less ink per second:

- Keep speed reducing the ink quantity

- Reduce speed keeping the ink quantity

I hope this answer helps

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...