We have a Latex 335 Print and Cut device and we have issues while printing. The printheads say they are in a good condition, and we have tried all of the recommended procedures for alignment, cleaning and image quality. Banding happens especially on Magenta prints Attached photos of test plot

Attachments

   latex5.jpg

   latex2.jpg

   latex4.jpg

   latex3.jpg

   latex1.jpg

Your test plots show a number of jets out on one of your magenta/yellow heads, and cyan/black heads. The printer will replace missing jets, but it has a limit as to how many. You may want to replace both of them and see if this helps. Also check the contacts in the head carriage to be sure they are clean. Hopefully this will solve your issue.

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel