Cancel search

Double sided printing on R2000

#1 jeremy.hildebrand 3 months ago

I'm printing on painted double-sided 3/8" mdf that is 49"x97". I've tried following what HP recommends to do, but my prints still come out not being lined up. I'm using Onyx as my rip. I have tried sending both sides as individual jobs, and just rotating the second side. I have tried sending it through Onyx layout software as well. I have tried left justifying side 1, and right justifying side 2. I have also tried center/center justified with clicking "full bleed" on the printer. Still nothing. SUGGESTIONS??

#2 Gaston Gomez 3 months ago

Good afternoon, check that the margins of the files in the RIP are equal, the ideal would be that they are all at 0 and manage them from the IPS of the printer, full bled is necessary if the image goes from board to edge if not selected. Try printing centered on the horizontal and at the top of the input margin

Was this helpful?Yes0 No0
How can we improve it?
#3 surendradhote448432 3 months ago

I am facing the same issue. Hope to have an answer here soon.

Thanks, Surendra Dhote https://www.themakersnow.com/

Was this helpful?Yes0 No0
How can we improve it?
#4 neil.mcnamara8439 3 months ago

Make sure the substrate is perfectly square. Measure corner to corner on each diagonal to confirm.

Was this helpful?Yes0 No0
How can we improve it?
#5 HP-daniel.donnelly5413 2 months ago

Hello jeremy.hildebrand, Can you reply with measurements and a description of how and where the print is off? Can the mdf be seen by the optical sensor for auto loading, or is the loading process manual?

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

Learn
A place to learn, grow and discover