Cancel search

.030 Magnetic on R1000

#1 lasarachie 3 years ago

Has anyone had any luck printing on vehicle magnet? .030 to be specific. If so, what preset did you begin with?

Thanks!

#2 HP Daniela Ciolompea 3 years ago

Hi @lasarachie,

It really depends on the magnetic coating. I would recommend starting from a film generic substrate and activate as a heat-sensitive. I hope this helps.

Was this helpful?Yes0 No0
How can we improve it?
#3 bjpopp 3 years ago

We have really good luck with .030 magnet on our R2000. The material loves moderate drying and curing temps. Your results might vary, but here's the settings we use. 8 Pass, 120 Ink Density- Optimizer: 28- Drying Temp: 65C- Curing Temp: 70C- Overcoat: Level 1- Printing Airflow: 100- Curing Airflow: 350

Was this helpful?Yes1 No0
100% of users thought this content was helpful.
How can we improve it?
#4 marcoss16845 2 months ago

#3 are you printing sheets or a full roll?

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.