My HP latex 375 print is wrong measurement when printing. Always i print 15 inches length on self adhesive vinyl; it lost 1inch. How can i solve this problem.

Try turning off the OMAS sensor in the medias advanced settings, then reprint and Measure.

Or make a 100" grid ruler file, then print it. Then measure it after the print on a flat table.

Most RIPs have a field in the printers settings that can be adjust the compensation of a file based on shrink and stretch of the media though the printer. Typically it is the amount of heat and tension being used to dry the ink that causes things to stretch or shrink.

Hello @bjorn.bedore5176

1 inch lost in 15 inches job, it is quite a lot. If this is correct maybe the job is cropped. If it was the case, maybe its something related to the RIP.

If you mean 1 millimeter? if yes then I will suggest playing with:

• Temperature
• Ink density
• Vacuum
• Take Up Reel tension
• OMAS on/off (with disabling this option when the media is not properly navigable).