-
Not at all likely
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
Extremely likely
Has anyone else experienced this wavy rippled pattern while printing? I am using an HP Latex 310 and printing on 3M IJ35C at 10 Pass with 100% Saturation and a temperature of 241. This pattern has been happening throughout the entire print (about 40'), and I'm not sure if it's a printing problem or a media problem. I have tried adjusting my heat levels, but that does not make a difference. I have also tried to clean an area with alcohol prior to printing and doing a test print to see if it is plasticizer issue. Any ideas would be greatly appreciated!