Cancel search

Substrate Jams on Startup - HP Latex 260

HP Latex 260 Printer

#1 jwurks a week ago

I have a HP latex 260 and I'm printing on HP adhesive gloss vinyl.

On startup, when the substrate advances and the carrier moves side to side, it always catches on the (right) edge of the substrate and causes a jam.

This results in me having to manually clear the jam, cut the substrate, and feed the substrate into the heating portion every time on startup. This solves the problem, but I'm wasting a lot of time and material.

Any thoughts?

#2 HP-Sonia a week ago

Hello @jwurks

There is more than one factor in this type of issue:

  • Please make sure you are using Hedge Holders.
  • Increase the value of the vacuum.
  • Media Roll: make sure that the roll has adapted to the room's temperature.

How to increase the vacuum 's values? GO TO: Image Quality Maintenance -> Adjust printing params -> Adjust Vacuum

I hope this information helps

Was this helpful?Yes1 No0
100% of users thought this content was helpful.
How can we improve it?
#3 jwurks a week ago

Hello Sonia,

I started using the edge holder on the right side, and my problem is fixed. However, it seems that my prints are now shifted about half an inch to the left. Is there a way to fix this?

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

Remember
To make recommendations or participate please Sign In and post a message.

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...