Cancel search

Latex 360 Printhead Alignment Failure

HP Latex 360 Printer

#1 Susanne 7 years ago

After replacing the printhead and attempting to do a printhead alignment we get a message, not an error, that says "Calibration cancelled due to substrate type/LED problem." On the top of the screen it then says "Printhead alignment has not been done" We have done this many times with success, we generaly use a 54" roll of Oracal vinyl for our alignments, not sure what the problem could be... Any insight would be greatly appreciated. Thanks!

#2 HP-MarcM 7 years ago

Hi Susanne,

I hope you are doing good.

Do you get the same message with a different substrate? Is the printer able to measure the roll width automatically? There may be an issue with a sensor in the carriage. If the printer continues with this behavior please contact your dealer in order to get proper and personalized help for this kind of issue.

Thank you in advance for the infromation.

Was this helpful?Yes0 No0
How can we improve it?
The opinions expressed above are the personal opinions of the authors, not of HP.

New comments are not available at this time

Latest conversations HP Latex

Loading...

HP Latex Blog

Loading...

How likely are you to recommend HP Large Format Knowledge Center to a colleague?
  • Not at all likely
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • Extremely likely
Thanks for your collaboration
To provide additional details, click here.